Chrysler — 1996 Jeep Grand Cherokee ZJ Service Manual
Pages 1–3 · 3 pages · 1 words repaired
SERVICE MANUAL and SUPPLEMENT
1996 JEEPT GRAND CHEROKEE
To order the special service tools used and illustrated, please refer to the instructions on inside back cover.
NO PART OF THIS PUBLICATION MAY BE REPRODUCED, STORED IN A RETRIEVAL SYS- TEM, OR TRANSMITTED, IN ANY FORM OR BY ANY MEANS, ELECTRONIC, MECHANICAL, PHOTOCOPYING, RECORDING, OR OTHERWISE, WITHOUT THE PRIOR WRITTEN PERMISSION OF CHRYSLER CORPORATION.
Chrysler Corporation reserves the right to make changes in design or to make additions to or improvements in its products without imposing any obligations upon itself to install them on its products previously manufactured.
Litho in U.S.A. Copyright © 1995 Chrysler Corporation 15M0895
NEXT PAGE ©
FOREWORD
The information contained in this service manual has been prepared for the professional automotive technician involved in daily repair operations. This manual does not cover theory of operation, which is addressed in service training material. Information describing the operation and use of standard and optional equipment is included in the Owner’s Manual provided with the vehicle.
Information in this manual is divided into groups. These groups contain general information, diagnosis, testing, adjustments, removal, installation, disassembly, and assembly procedures for the system and components. To assist in locating a group title page, use the Group Tab Locator on the following page. The solid bar after the group title is aligned to a solid tab on the first page of each group. The first page of the group has a contents section that lists major topics within the group. If you are not sure which Group contains the information you need, look up the Component/System in the alphabetical index located in the rear of this manual.
A Service Manual Comment form is included at the rear of this manual. Use the form to provide Chrysler Corporation with your comments and suggestions.
Tightening torques are provided as a specific value throughout this manual. This value represents the midpoint of the acceptable engineering torque range for a given fastener application. These torque values are intended for use in service assembly and installation procedures using the correct OEM fasteners. When replacing fasteners, always use the same type (part number) fastener as removed.
Chrysler Corporation reserves the right to change testing procedures, specifications, diagnosis, repair methods, or vehicle wiring at any time without prior notice or incurring obligation.
NEXT PAGE ©
NOTE: Groups with the suffix “-S” are Supplements to the original service manual publication.
IN Introduction
0 Lubrication and Maintenance
0-S Lubrication and Maintenance
2 Suspension
3 Differential and Driveline
3-S Differential and Driveline
5 Brakes
7 Cooling System
8A Battery
8B Starting Systems
8C Charging System
8D Ignition System
8E Instrument Panel Systems
8F Audio Systems
8G Horn Systems
8H Vehicle Speed Control System
8J Turn Signal and Hazard Warning Systems
8K Wiper and Washer Systems
8L Lamps
8M Passive Restraint Systems
8N Electrically Heated Systems
8P Power Lock Systems
8Q Vehicle Theft/Security Systems
8R Power Seat Systems
8S Power Window Systems
8T Power Mirror Systems
8U Chime/Buzzer Warning Systems
8V Overhead Console Systems
8W Wiring Diagrams
9 Engine
11 Exhaust System and Intake Manifold
13 Frame and Bumpers
14 Fuel System
19 Steering
21 Transmission and Transfer Case
21-S Transmission and Transfer Case
22 Tires and Wheels
23 Body
24 Heating and Air Conditioning
25 Emission Control Systems
Component and System Index
Supplement Component and System Index
Service Manual Comment Forms (Rear of Manual)